MODIFIKASI PENGUNCI KEPALA LEPAS UNTUK MESIN BUBUT MAXIMAT V13

  • Intan Rahma Yuni Politeknik Negeri Padang
  • Arif Rahman Politeknik Negeri Padang
  • Elvis Adril Politeknik Negeri Padang
  • Yuli Yetri Politeknik Negeri Padang
Keywords: Tailstock lock, material strength, modification

Abstract

During this time the tailstock off which is commonly used is made of castings which is difficult to obtain and the price is quite expensive, and it becomes on obstacle to replace it if there is damage or loss of locking the “tailstock”. For modifying it can be done in order to facilitate the use of machine, which is the modification of the tailstock release on the lathe because the design was previously damage and cannot be used properly and also makes locking more efficient and better than before. With the right material selection and material calculation, the desired target will be achieved perfectly and the use will ber very helpful in the use of loose heads on the lathe.

Downloads

Download data is not yet available.

References

Sato. Takeshi, “Menggambar Mesin Menurut Standar ISO”, Jakarta: Pradyana Paramita, 1990.

Sularso, “Dasar Perencanaan Dan Pemilihan Elemen Mesin Edisi Ke-6”, Jakarta: Pradyana Paramita, 1987.

R.S Khurni. J.K Gupta, “A Text Book of Machine Deasign”, New Delhi, 1982.

Sonawan. Hery, “Perancangan Elemen Mesin”, Bandung: Alfabeta, 2010.

Warren J. Luzadder, “Menggambar Teknik”, Surabaya: Erlangga, 1981.

Suratman. M dan Ir. Ohan Junana, “Menggambar Teknik Mesin Dengan Standar ISO. Bandung: Pustaka, 2000.

Sanda, “Analisa Dimensi Lengan Pada Model Rancangan Renograf Thyroid Uptake Terpadu”, Volume 12 (hlm.30-37), 2015.

Yudhyadi. Rachmanto dan Ramadan, “Optimasi parameter permesinan terhadap waktu proses pada pemrograman CNC”, Volume 6 (hlm.38-50),2016.

Hadimi, “Atur putaran mesin (rpm) sesuai dengan diameter benda kerja yang sedang dikerjakan”, Volume 11(hlm.18-28), 2008.

Naharuddin, AlimuddinSam dan Nugraha Candra, “Kekuatan Tarik dan Bending Sambungan Las Pada Material Baja SM 490 Dengan Metode Pengalasan SMAW dan SAW”, Volume 6 (hlm.550-555), 2015.

Published
2020-10-31

Most read articles by the same author(s)